SMT stencil printers

How to Use NeoDen FP2636?

1. Preparation

FP2636 stencil printer, frameless stencil, PCB, accessory box, solder paste, Stirring knife, scraper blade.

L-shaped seats 5Pcs\L-shaped wrenches 2Pcs\positioning pins: 1mm 4Pcs, 1.5mm 4Pcs, 2mm 4Pcs, 2.5mm 4Pcs, 3mm 4Pcs\support steel column 15Pcs\Fixing screws 5Pcs.

2. Install the frameless stencil

Loosen the four "Set screw", adjust the "rear stencil fixing platen" to a suitable position, loosen the 8 screws on the front and rear stencil fixing platen, and put in the "frameless stencil", tighten the screws.

3. Place the PCB

Install four "L-shaped seats" and "positioning pins" according to the actual positioning holes on the PCB (PS: Due to the limited XY adjustment range, the position of the "PCB" should be as close as possible to the hole location of the frameless stencil)，if the PCB is easy to deform, you can install the copper pillar underneath according to the size of the PCB.

4. Adjust the stencil

Adjust the "height adjustment handle" to adjust the height of the stencil, adjust the x, y and angle adjustment handle to adjust the X/Y position (PS: leave a gap of about 0.5mm between the surface of the PCB and the stencil).